Publicidad
Idiomas disponibles
Idiomas disponibles
This tool is in accordance with the relevant
safety regulations. Have your tool repaired by
an authorised BTI repair agent. Repairs should
only be carried out by qualified persons using
original spare parts; otherwise this may result
in considerable danger to the user.
Safety instructions for chargers and battery
packs
• Only use battery packs that are intended to be
used with the tool.
• Make sure that the battery pack is dry and
clean before inserting it into the charger.
• A battery pack must only be charged using the
charger recommended with the battery pack.
Incorrect use may result in a risk of electric shock,
or overheating or leakage of the battery pack.
• Never carry the charger by its cord. Never pull
the cord to disconnect from the socket. Keep
the cord away from heat, oil and sharp edges.
• Always follow the instructions in the back of
this manual for battery pack disposal.
• When not in use, chargers and battery packs
must be stored in a dry place and locked up
securely, out of reach of children.
Additional safety instructions for battery packs
Fire hazard! Avoid metal short
circuiting the contacts of a detached
battery pack. Do not store or carry the
battery pack without the battery cap
placed over the contacts.
• The battery fluid, a 25-30% solution of
potassium hydroxide, can be harmful. In case
of skin contact, flush immediately with water.
Neutralize with a mild acid such as lemon juice
or vinegar. In case of eye contact, rinse
abundantly with clean water for at least 10
minutes. Consult a physician.
• Never attempt to open a battery pack for any
reason.
Labels on charger and battery pack
In addition to the pictographs used in this
manual, the labels on the charger and the battery
pack show the following pictographs:
Battery charging
Battery charged
Battery defective
Do not probe with conductive objects
Do not charge damaged battery packs
Read instruction manual before use
Use only with BTI battery packs,
others may burst, causing personal
injury and damage
Do not expose to water
Have defective cords replaced
immediately
Charge only between 4 °C and 40°C
Discard the battery pack with due
care for the environment
Do not incinerate the battery pack
Charges NiMH and NiCd battery
packs
See technical data for charging time
Additional safety rules for cutsaws
Switching on and off
• After switching off, never attempt to stop the
saw blade with your fingers.
• Never put the saw down on a table or work
E N G L I S H
31
Publicidad
