Descargar Imprimir esta página

BTI RS 18V Manual Del Usuario página 32

Publicidad

Idiomas disponibles

Idiomas disponibles

E N G L I S H
bench unless switched off. The saw blade will
keep running briefly after the tool has been
switched off.
When sawing
• When using saw blades specially designed for
cutting wood remove all nails and metal objects
from the workpiece before starting work.
• Wherever possible, use clamps and vices to
fasten the workpiece securely.
• Do not attempt to saw extremely small workpieces.
• Do not bend too far forward. Make sure that
you always stand firmly, particularly on
scaffolding and ladders.
• Always hold the saw with both hands.
• For cutting curves and pockets, use an
adapted saw blade.
Checking and changing the saw blade
• Only use saw blades conforming to the
specifications contained in these operating
instructions.
• Only sharp saw blades in perfect working condition
should be used; cracked or bent saw blades
should be discarded and replaced at once.
• Ensure that the saw blade is securely fixed.
Package contents
The package contains:
1 Cordless reciprocating saw
1 Saw blade
1 Battery packs, NiCd
1 Charger
1 Kitbox
1 Instruction manual
1 Exploded drawing
• Check for damage to the tool, parts or
accessories which may have occurred during
transport.
• Take the time to thoroughly read and
understand this manual prior to operation.
Description (fig. A)
Your BTI-RS 18V cordless reciprocating saw has
been designed for professional sawing of wood,
metal and tubes. The compact design permits
cutting extremely close to the edge of difficult
areas.
32
1 Variable speed switch
2 Lock-off button
3 Blade clamp slider
4 Saw shoe
5 Battery pack
Charger
Your charger BTI-LG 18V accepts BTI NiCd/NiMH
battery packs ranging from 7.2 to 18 V.
5 Battery pack
6 Release buttons
7 Charger
8 Charging indicator (red)
Electrical safety
The electric motor has been designed for one
voltage only. Always check that the battery pack
voltage corresponds to the voltage on the rating
plate. Also make sure that the voltage of your
charger corresponds to that of your mains.
Your BTI charger is double insulated in
accordance with EN 60335.
Mains plug replacement (U.K. & Ireland
only)
• Should your mains plug need replacing and
you are competent to do this, proceed as
instructed below. If you are in doubt, contact an
authorized BTI repair agent or a qualified
electrician.
• Disconnect the plug from the supply.
• Cut off the plug and dispose of it safely; a plug
with bared copper conductors is dangerous if
engaged in a live socket outlet.
• Only fit 13 Amperes BS1363A approved plugs
fitted with the correctly rated fuse (1).
• The cable wire colours, or a letter, will be
marked at the connection points of most good
quality plugs. Attach the wires to their
respective points in the plug (see below).
Brown is for Live (L) (2) and Blue is for Neutral
(N) (4).
• Before replacing the top cover of the mains
plug ensure that the cable restraint (3) is
holding the outer sheath of the cable firmly and
that the two leads are correctly fixed at the
terminal screws.

Publicidad

loading