Publicidad
Idiomas disponibles
Idiomas disponibles
Pocket cuts
• Measure and mark the required pocket cut.
• Using a narrow saw blade rest the bottom of
the saw shoe on the workpiece and make sure
that the blade is positioned on the cutting line.
If necessary, e.g. in confined spaces, use the
outer edge of the saw shoe as your guideline.
• Switch on the tool and feed the blade into the
material at full speed, holding the tool firmly
against the workpiece.
Dust extraction
• When the tool is used indoor for extended
periods of time, use a suitable dust extractor
designed in compliance with the applicable
Directives regarding dust emission.
Cutting metal
• When cutting thin metal always stabilize the
workpiece with wood on both sides. This
guarantees clean cuts and prevents damaging
of the material.
• For long, straight cuts draw a line on the
workpiece.
• Apply a thin film of lubricant along the cutting
line, switch on the tool and follow the cutting line.
Cutting plastics
• Always work at reduced speed. Carry out a test
cut to check whether the material is sensitive to
heat.
Cutting masonry
When sawing asbestos cement
hazardous dust may be produced.
Follow the statutory guidelines and
observe the recommendations issued
by the asbestos cement manufacturers.
Consult your dealer for further information on the
appropriate accessories.
Maintenance
Your BTI power tool has been designed to
operate over a long period of time with a
minimum of maintenance. Continuous
satisfactory operation depends upon proper tool
care and regular cleaning.
Lubrication
Your power tool requires no additional lubrication.
Cleaning
• Unplug the charger before cleaning the housing
with a soft cloth.
• Remove the battery pack before cleaning your
power tool.
• Keep the ventilation slots clear and regularly
clean the housing with a soft cloth.
Environment
Rechargeable battery pack
This long life battery pack must be recharged
when it fails to produce sufficient power on jobs
which were easily done before. At the end of its
technical life, discard it with due care for our
environment:
• Run the battery pack down completely, then
remove it from the tool.
• NiCd and NiMH cells are recyclable. Take them
to your dealer or a local recycling station.
The collected battery packs will be recycled or
disposed of properly.
Unwanted tools
Take your tool to an authorised BTI repair agent
where it will be disposed of in an environmentally
safe way.
E N G L I S H
35
Publicidad
