Publicidad
Idiomas disponibles
Idiomas disponibles
GB
time of the saw chain is reduced,
since the chain becomes blunt fast-
er. You can identify a case of too
little oil where smoke development
or discoloration of the rail occurs.
The chainsaw is equipped with an auto-
matic oiling system. As soon as the motor
is speeded up, the oil also flows faster to
the chain bar (4).
Filling up with chain oil:
• Check the oil fill level and regularly top
up with oil ( 25). The oil tank holds
220 ml of oil.
• Use Grizzly bio-oil; this product con-
tains additives that reduce wear and
tear and does not damage the pump
system. bio-oil is available from our
Service-Center.
• If you have no Grizzly bio-oil available,
use chain lubrication oil with low adhe-
sive additive content.
1. Unscrew the oil fill cap (2) and fill
D
up with chain oil.
2. Wipe off any spilled oil and close
the cap again.
Always switch off the device and
allow the motor to cool before
filling with chain oil. There is a
risk of fire if oil overflows.
Operating
Switch on the chainsaw only when
chain bar, saw chain and sprocket
chain wheel covering are correctly
assembled.
Make sure you have a secure
stance. Before starting, ensure that
the electric chainsaw is in contact
with no objects.
84
Caution! Saw can oil up, see notes
on Operation startup.
E
Indicator charge level
Press the „Press" button on the right of
charging level indicator (
to check the status of the battery.
The number of illuminated LED lights
shows the charge level of the battery.
F
Removing / inserting the
battery
1. To remove the battery (19) from the
appliance, press the release button
19a) on the battery and pull out the
E
(
battery.
2. To insert the battery (19), place it on the
guide track (17) and push it back into
the appliance. It will audibly snap in.
Switching on
G
1. Check before the start, whether suffi-
cient chain oil is in the tank and, if nec-
essary, refill with chain oil (see Chapter
"Operation startup").
- the charge status of the battery
).
E
(see
2. Release the chain brake, where you
shift the brake arm (3) back against
the front grip (8).
3. Hold the chainsaw firmly with both
hands, with the right hand on the rear
grip (1) and the left hand on the front
handle (8). Thumb and finger must
close securely over the handles.
4. For switching on, activate the switch-
on block (10) with the right thumb and
then press the On/Off switch (11), the
chainsaw runs with highest speed.
Release the switch-on block again
5. The power saw switches off when you
release the On/Off switch (11) again.
19b), in order
E
Publicidad
