Publicidad
Idiomas disponibles
Idiomas disponibles
Switching for continuous running is not
possible.
Checking the chain brake
The motor cannot be turned on if the
chain brake has engaged. Do not
employ the chain brake in order to
start the chainsaw or to switch it off.
1. Place the chainsaw onto a solid,
H
flat surface. It must not contact
any objects.
2. Release the chain brake, where
you shift the brake arm (3) back
against the front grip (8).
3. Hold the chainsaw firmly with
both hands, with the right hand
on the rear handle (
left hand on the front handle
8). Thumb and finger must
(
G
close securely over the handles.
4. Turn on the chainsaw.
5. Activate the chain braking lever
(3), with running motor, with the
left hand. To do so, push the
chain braking lever/front hand
protection (3) away from the front
handle (8).
Chain should stop abruptly.
6. Once the chain brake is work-
ing properly, release the on/off
switch (10) and the chain brake.
If the chain brake does not func-
tion correctly, you must not use
the chainsaw. A slack saw chain
leads to danger of injury. Return
the chainsaw to our Service-
Center for repair.
Checking the oil automatic
system
Check the oil level and the automatic oil
system before commencement of work.
•
I
B
1) and the
G
1. Lay the saw on a flat surface.
2. Turn the fastening bolt (13) and the
3. Remove the saw bar (4) saw chain (5).
4. For assembly, see „Assembling the
Sawing techniques
General
Switch on the chainsaw and hold it
above a bright background. The saw
must not touch the ground.
If an oil trace can be seen, the chain-
saw is working trouble-free.
If no oil trace can be seen clean
the oil passages or turn the
chainsaw to our Service-Center for
repair.
Clean the oil passages of the chain
bar (26), in order to guarantee a
trouble-free, automatic oiling of the
saw chain during operation.
Change the blade / saw-
ing chain
screw for the chain quick-tensioning
system (14) in counter-clockwise
direction in order to loosen the chain
tension and to remove the sprocket
chain wheel cover (15).
To remove the guide bar (4), raise it
to an angle of approx. 45 degrees.
This will make it easier to take the saw
chain (5) off the sprocket (24).
blade and the sawing chain"
Refer to the start-up section on
how to tension the saw chain.
Observe the noise protection and
local regulations when cutting wood.
Local requirements may require a
suitability test. Ask the forestry com-
mission.
GB
85
Publicidad
