Garant 654410 Manual De Instrucciones página 28

GARANT Electronic Torque Tester HCT
de
Settings
11.1. SETTING THE MODE
en
B
i
bg
The torque tester has five modes:
Track
da
Track HCT (only 654410)
1st Peak
fi
Peak Hold
fr
Peak Hold HCT (only 654410)
it
ü Device is showing the start screen.
1. Right function button (5), enter password if necessary and confirm with OK (8).
hr 2. Select "Mode" and confirm with OK (8).
3. Select the desired test mode using the left/right direction buttons (2, 4) and confirm with OK (8).
» Mode is set.
lt
Back to Menu navigation [} Page 27]
11.2. MANAGING HISTORY
nl
B
i
no
A maximum of 1000 entries can be saved. The oldest entries are overwritten.
ü Device is showing the start screen.
1. Press right function button (5), enter password if necessary and confirm with OK (8).
pl
2. Select "History" and confirm with OK (8).
3. Select entry.
» In order to display details, press OK (8).
pt
» In order to delete all entries, press and hold the right function button (5) for three seconds and confirm with OK (8).
Back to Menu navigation [} Page 27]
ro 11.3. MANAGING TEST CASES
11.3.1. Adding a test case
C
sv
i
A maximum of 20 test cases can be saved.
sk
ü Device is showing the start screen.
1. Press right function button (5), enter password if necessary and confirm with OK (8).
2. Select "Test Case" and confirm with OK (8).
sl
3. Select "Add a test case" and confirm with OK (8).
4. Using the direction buttons, assign a name with a maximum of four characters.
5. Confirm with OK (8).
es
6. Using the left/right direction buttons (2, 4) select whether the test case should be password protected, and confirm with
OK (8).
i
cs
With an activated password: Password must be entered in the case of an incorrectly executed tightening procedure.
7. Configure settings according to Setting the mode [} Page 28].
» Test case saved.
hu
Back to Menu navigation [} Page 27]
28
Managing settings [} Page 30]
For measuring torques in general without specifying a target
value or evaluation.
For measuring torques in general with HCT torque wrenches,
without specifying a target value or evaluation.
For mechanical, triggering torque wrenches. The torque ap-
plied during mechanical triggering is determined.
For digital, displaying torque wrenches. The highest torque
applied within the set evaluation time (see Measurement
[} Page 30]) is determined.
For digital, displaying HCT torque wrenches. The highest
torque applied is determined.