Garant 654410 Manual De Instrucciones página 31

Master PWD
Test case PWD
Overload info
Back to Menu navigation [} Page 27]
12. Operation
12.1. CONNECTING AN HCT TORQUE WRENCH (ONLY 654410)
C
NOTICE! When connecting to an HCT torque wrench, no settings may be configured on it before or after con-
necting.
Without activated HCT mode
ü Bluetooth is activated on the HCT torque wrench and the torque tester. Bluetooth symbol flashes on both devices.
ü Torque tester is showing the start screen.
1. Press right function button (5), enter password if necessary and confirm with OK (8).
2. Select "Connections" and confirm with OK (8).
3. Select "SEARCH FOR HCT devices" and confirm with OK (8).
» List of available devices is shown.
4. Select desired HCT torque wrench and confirm with OK (8).
» HCT torque wrench is connected. "Track HCT" mode is activated.
5. Select the desired mode or test case on the torque tester.
With activated HCT mode or HCT test case
ü Bluetooth is activated on the HCT torque wrench and the torque tester. Bluetooth symbol flashes on both devices.
ü Torque tester is showing the start screen.
1. Press the left function button (1).
» List of available devices is shown.
2. If "Quick Connect" is ON, see Managing connections (only 654410) [} Page 29], press send button on HCT torque
wrench.
3. Select desired HCT torque wrench and confirm with OK (8).
» HCT torque wrench is connected.
4. Select the desired mode or test case on the torque tester.
12.2. TESTING THE TORQUE WRENCH (ONLY 654410)
WARNING
Torque wrench not fully inserted.
Lacerations and impacts due to slipping of the torque wrench, resulting in uncontrolled high-energy movements of all com-
ponents.
» Ensure the square socket drive/hexagon of the drive interface is clean.
» Fully insert the external square drive/hexagon drive of the torque wrench into the drive interface of the torque tester.
1. Connect the torque wrench to the drive interface of the torque tester up to the stop.
12.2.1. Measuring torques in general
C
ü "Track" mode is selected.
1. Move the torque wrench slowly and evenly.
2. Read off the measurement values on the display of the torque tester.
3. To start a new measurement, press the Send button (6) or move the torque wrench in the desired rotation direction
again.
Activate or deactivate master password. Password is requested when
opening the menu.
Activate and select/deactivate password for test cases. When creating the
test case, the password must also be activated.
Display of overload cases.
www.hoffmann-group.com
de
en
bg
da
fi
fr
it
hr
lt
nl
no
pl
pt
ro
sv
sk
sl
es
cs
hu
31