illy Iperespresso X7.1 Instrucciones De Uso página 32

TO MAKE CAPPUCCINO
EN
The steam wand which comes with the machine allows you to froth milk for cappuccino.
Make one or more cups of coffee, following the instructions above. To froth the milk:
1
When the machine reaches the
Press the steam button ;
required temperature, the
the steam symbol on the dial
button lights up.
lights up to indicate that the
The machine emits a beep.
machine is preparing to enter
"steam" mode.
Carefully remove all residue of milk from the steam wand after
5
each use:
• Press and hold the
• Press the
• Allow the machine to cool down for a few minutes.
X • Remove the tip Z and wash it under running water.
Z
• Clean the internal nozzle X with a damp cloth.
NOTE: Both parts of the steam wand are dishwasher-safe.
Before placing them in a dishwasher, remove the inner
part of the metal tube. After cleaning, slide the inner
nozzle X onto the steam tube and push until it clicks into
place. Then fit the outer tip Z back into place.
32
2 3
Insert the steam wand into
a suitable (preferably metal)
empty recipient and press the
button to drain off remain-
ing water; once the wand is
emitting only steam, press the
button again to stop it.
button for a few seconds. Release.
button again.
NOTE: When the steam
wand is dispensing steam,
the button flashes.
Pour some cold milk into a
suitable recipient (preferably a
metal jug).
NOTE: For best results: pour
75 ml of whole cold milk,
taken fresh from the fridge,
into a suitable recipient
(preferably a metal jug) and
immerse the steam wand in
Fully immerse the steam wand in the milk.
the milk for no more than
Press the
25 seconds.
Once the milk is foamed to the right consistency, press the button
again to stop frothing
CAUTION:
- The steam wand and the steam it dispenses can cause serious burns.
- When the steam function has been inactive for about 5 minutes, the machine
automatically returns to coffee-maker mode; one minute before switching mode,
the button begins to flash. Press this button to remain in steam mode.
- During the heating phase and once it's in steam mode, the machine brings the
thermoblock up to temperature. This may cause small amounts of steam to escape
from the capsule holder: to avoid the risk of scalding, keep the hands and other
parts of the body well away from the coffee dispensing head.
4
button to froth the milk.
.