Paslode CF150-PP Manual De Funcionamiento página 14

Preparing the Paslode Cordless 1-1/2" Positive Placement
Metal Connector Nailer for Use
Fasteners
The Paslode Cordless 1-1/2" Positive Placement
Metal Connector Nailer drives Paslode 1-1/2" Positive
Placement ® Metal Connector Nails designed to be used
with the tool. The use of fasteners that do not meet
Paslode standards could cause tool damage and will
void all warranty claims.
Lockout Feature
The purpose of this feature is to prevent needless
blank cycling, which could mar woods,waste fuel and
damage tool components . Five (5) nails will be left in
the magazine when the follower reaches the lockout
area. When changing fastener length or loading at
the beginning of the work day, you should inspect the
magazine and nose for any fasteners left in the tool.
These nails will not be visible unless you open the
nose of the tool.
CORRECT NAIL LOADING PROCEDURE
Slide nail strip into back
of magazine
Paslode Cordless 1-1/2" Positive
Placement Metal Connector Nailer
®
and Outdoor Weather
Use the Cordless Nailer outdoors, in dry weather,
when the nailer, fuel cartridge and battery are
between 45º (7.2ºC) and 120ºF (49ºC).
HOT WEATHER OPERATION
The Cordless Nailer requires cooling of the motor
assembly to operate properly. The fan normally
provides the necessary air flow to permit continuous
operation. Whenever the Cordless Nailer is idle for
extended periods, keep the fuel and tool out of
direct sunlight and in surroundings where
temperatures will not exceed 120ºF (49ºC). After
extended periods of continuous use, it may be
necessary to cool the motor by setting tool aside for
10-15 minutes or until the tool operates normally. An
overheated tool may not drive nails completely or
may operate erratically.
®
Depress lever, then pull nail
follower back past nail strip
COLD WEATHER OPERATION
When storing the Cordless Nailer in temperatures
below 45°F (7.2°C) it may be necessary to first warm
up the fuel and tool for proper operation.
Fuel cartridges at colder temperatures can lose their
required propellent pressure. To correct this simply
warm up the fuel cartridge by placing it in an inside
coat pocket for several minutes.
Once the fuel is warm, insert the cartridge into the tool.
Quickly depress the tool two times onto the work
sur face and hold the tool in the down position after
the second actuation. Wait one or two seconds then
pull the trigger. This action is referred to as "double
pumping" and provides a richer fuel mixture to the
cold tool to help initiate combustion.
14
Use only Paslode 1-1/2"
Positive Placement
®
Metal Connector Nails
Gently release follower onto rear
of nail strip, to prevent collation
damage
®