Publicidad
Idiomas disponibles
Idiomas disponibles
Paslode Cordless 1-1/2" Positive Placement
Metal Connector Nailer Operation
Cold Weather Operation: (Continued)
It will be necessary to repeat this procedure several
times until the temperature of the tool warms up enough
to operate in it's normal mode.
Once the tool reaches operational temperature the tool
will generate it's own heat and will function normally.
If the tool sits for an for an extended period of time and
cools down it may be necessary to repeat these steps.
During the warm-up process, never expose the
tool, fuel cartridge, or battery to flame.
The Cordless Nailer should not be used
in the rain or where excessive moisture is present.
The use of the Paslode Cordless Technology under
®
these conditions may result in damage to tool
components and cause the tool to malfunction.
WARNING
CAUTION
PRESS NAIL HOLE
LOCATION PROBE
AGAINST THE
WORK
SURFACE.
Fan motor starts,
fuel is injected into
combustion cham-
ber and mixed with
air by the fan.
SQUEEZE TRIGGER
Spark plug ignites
the fuel/air mixture,
driving the piston
assembly down on
the fastener.
RELEASE TRIGGER
- LIFT TOOL
Combustion
chamber opens.
Fan exhausts,
cooling internal
components.
The Nail Hole Location Probe and nose will become
hot after prolonged or rapid use. If it becomes
necessary to adjust the Nail Hole Location Probe,
avoid touching with bare hands.
This tool must be operated in a well ventilated environ-
ment, because the tool exhausts carbon monoxide
similar to a chainsaw or lawn mower. Exposure to
carbon monoxide may cause dizziness, nausea or
unconsciousness.
Depth of Drive Adjustment
Remove the battery before adjusting the depth of
drive.
The depth of drive adjustment is done by turning the
adjustment wheel as shown by the arrows on the side of
the tool.
Counter
Sunk
DECREASE
DEPTH OF DRIVE
15
®
DANGER
CAUTION
INCREASE
DEPTH OF DRIVE
Proud
Publicidad
