Publicidad
Idiomas disponibles
Idiomas disponibles
Servicing
CLEARING A FASTENER JAM
Remove the magazine
assembly to expose
the back of the nose
slot. (Be careful the
nail follower does not
come out of the
magazine channel)
End-of-Workday Routine
These simple steps are based on maintaining the safety and
operational efficiency of the Cordless Nailer.
Before you leave the work site:
1.
R
e
m
o
v
e
b
t a
e t
y r
a
n
d
s
Cordless Nailer case for transporting and storing
the tool.
2. Dispose of all empty fuel cartridges. Remember to
dispose of these fuel cartridgeas where they will not
be crushed, punctured, burned or found by children.
When you get home:
1. Place the battery in its charger if it needs charging as
indicated by the red charge light on the handle.
2. Wipe your Cordless Nailer with a clean soft cloth.
3. Remove and clean the filter every two days.
4. Check Nail Hole Locating Probe to ensure it is
operating freely.
Tool Cleaning and Oiling
Periodic cleaning and oiling are necessary to keep the
Paslode Cordless Nailer operating properly. The tool
should be cleaned and lubricated at least every 50,000
cycles. This number may vary depending upon the rate at
which the tool is used and the operating conditions it is
used in. The chart in the cleaning instructions will help you
determine how often the tool should be cleaned.
Remove Battery, Fuel
Cell and Nails
Push or punch the
driver blade back to
top rest position,
using a long punch (if
needed)
o t
e r
n i
o t
o
c l
a
s
. e
A
w l
a
s y
u
Remove 2 cap
screws on side of
magazine securing
magazine to the nose
With driver blade
clear, operator is free
to remove jammed or
bent nail
Paslode Cordless Tool Accessories
A variety of accessories are available for the Paslode
Cordless 1-1/2 " Positive Placement
Nailer:
Battery - Part No. 902654
s
e
h t
e
Tool Cleaner - Part No. 219348
Clear Safety Glasses - Part No. 401382
Paslode Cordless Lubricating Oil - Part No. 401482
Battery Charger - Part No. 902672
Paslode Cordless 1-1/2" Positive Placement
Connector Nailer Case - Part No. 906107
Contact your Paslode® representative for additional
information.
Tools
A 9/64 Hex Wrench (Part No. 900736) is provided with
each Cordless 1-1/2" Positive Placement
Connector Nailer.
For technical support call:
17
Remove nut from rear
of magazine.
Reassemble tool,
attach magazine to
nose, replace cap
screws and nut. Tool
is ready to use.
®
Metal Connector
®
1-800-222-6990
or email:
tech@paslode.com
®
Metal
Metal
Publicidad
