Descargar Imprimir esta página

Paslode CF150-PP Manual De Funcionamiento página 9

Clavadora inalámbrica

Publicidad

Idiomas disponibles

Idiomas disponibles

Battery and Charging System
Important Charging Notes
The Paslode Cordless 1-1/2" Positive Placement
Metal Connector Nailer comes with a rechargeable
battery and its own charging system. This charging
system is the only one that will work with the
Paslode lithium-ion batteries. The first step in
preparing a new tool for operation is to fully charge
the battery. New batteries are shipped partially
discharged and must be charged prior to first
use. Batteries will take 5 minutes to 1.5 hours (time
will be dependent on the amount of discharge of the
battery) to recharge.
Battery
THE PASLODE BATTERY CHARGING SYSTEM
Charging System Accessories:
Battery Charger - Part No. 902672
®
Warning
CHEMICAL/EXPLOSION
HAZARD
Read ALL instructions be-
fore charging or using bat-
tery. Failure to follow ALL
instructions may result in
fire, severe burns, or re-
lease of toxic materials.
6ft. Cord
Charger
Charging Instructions
1.
Remove the charger unit from the tool case and plug
it into a 120V AC outlet. Set the charger base on a
stable surface. A green light will come on to indicate
the power is on and the charger circuit is ready.
2. Remove the battery from tool or case and insert ter-
minals down into charger. The red light will come on
indicating that the battery is charging and the green
light will go out.
Note
If battery is completely discharged, the red light and
the green light may alternate back and forth for up to
20 minutes. This safety feature slowly recharges the
battery until it is ready to accept the full charging
current. If the red and green lights continue to alter-
nate after 20 minutes, replace the battery.
3. After charging is complete, the red light will go out
and the green light will come on, indicating that the
battery is fully charged. The charger will keep the
battery at full charge until it is removed.
4. Unplug the charger from the 120V AC outlet.
CHARGING TIMES:
First charge (new battery)
Discharged Battery
CHARGING DON'TS:
1. Do not charge battery outdoors or in temperatures
below 40°F (5°C).
2. Do not allow metal objects to come in contact with
battery terminals.
3. Do not puncture or attempt to open battery case or
cells.
4. Do not store battery where it will be subjected to
temperatures above 120°F (49°C).
5. Do not incinerate battery.
6. Do not use a defective battery charger, one that
over-heats and/or smokes when plugged in.
7. Do not immerse the battery or charger in water.
Battery disposal:
The Paslode batteries contain lithium and should be re-
cycled or disposed of properly.
You may contact your local recycling center for information
on where to return the spent battery or call 1-800-822-8837
for information on Li-ion battery recycling in your area.
9
1.5 hour
5 minutes to 1.5 hour

Publicidad

loading

Este manual también es adecuado para:

906200