User Section; Remote Controller; Description Of The Display - MAXA 3500 W Manual Usuario/Instalador

III. USER SECTION

1. REMOTE CONTROLLER

1.1. Instructions for use
The following operations can be carried out using the remote control and/or the wire control
see the instructions for use provided with the same:
• Switching the unit on/off,
• Selection of the three fan speeds.
• Adjusting the thermostat and maintaining the desired ambient temperature.
• Switching between the cooling/heating operating cycle.
The unit panel houses a number of indicators which provide information on the unit status
or alarm signals. If the remote control and/or wire control are temporarily unavailable, they
can be used to operate the unit in manual mode using the MANUAL key.
Note:
The remote control can be used to set and display all the unit operating parameters,
facilitating the all programming operations. The remote control is powered by two 1.5V
AAA R03 batteries.
IMPORTANT!
It is advisable to test the remote control in order to establish its reception zone.
1.2. Description of the remote control and relative functions
(1) Transmits the infrared signals to the unit receiver.
(2) Indicates the unit status and operating modes.
(3) Makes it possible to switch the unit on and off. Press the key once to switch it on, press
it again to switch it off.
(4) Makes it possible to select the desired operating mode (AUTO, COOL, DRY, HEAT,
FAN).
(5) These keys make it possible to set the desired ambient temperature. ▲the requested
temperature is increased up to 30 °C ▼ the requested temperature is decreased down to
17 °C. Every time the key is pressed the temperature is changes with 1°C.
(6) Press this key to select the fan speed. When you select AUTO, the fan speed is
automatically regulated on the basis of the ambient temperature. It is also possible to
select the fan speed manually, choosing between 3 settings: LOW, MED (MEDIUM);
HIGH.
(7) Makes it possible to set the louver angle.
(8) This key enables the louver to swing vertically (horizontally).
(9) This function is not available in the units.
(10) Press these keys to set the unit on/off timer.
(11) Makes it possible to lock all the remote control functions.
(12) Press this button to reset the remote control settings.

1. 3. Description of the display


Transmission indicator appears whenever a signal is transmitted to the internal unit.

Operating mode display (MODE): Indicates the selected mode.

ON/OFF display: Indicates that the unit is in operation.

Temperature display (TEMP): Indicates the set temperature (from 17°C to 30°C). When
the FAN operating mode is selected, no temperature is displayed.

Lock display: Indicates that the remote control is locked.

Timer display (TIMER ON). If you press the TIMER ON key, the timer on time is displayed.

Timer display (TIMER OFF). If you press the TIMER OFF key, the timer off time is displayed.

Fan speed display (FAN): Indicates the selected fan speed. It may be displayed as AUTO or one of the three speeds:
LOW, (MED) MEDIUM, HIGH.
41
。
SETTING TEMP( )
( C)
FAN
AUTO
HIGH
COOL
MED
DRY
LOW
HEAT
TEMP
ON/OFF
MODE
FAN SPEED
TIMER ON
SWING ECONOMY
SWING TIMER OFF
RESE T LOCK
AIR
DIRECTION
1
。
SETTING TEMP( )
( C)
FAN
AUTO
HIGH
COOL
2
MED
DRY
LOW
HEAT
TEMP
5
ON/OFF
MODE
FAN SPEED
4
SWING ECONOMY TIMER ON
8
TIMER OFF
SWING
RESET LOCK
8
AIR
DIRECTION
12
7
1
2
4
8
5
TIMER ON OFF
6,7
5
3
6
10
9
10
11
3
2