Parkside PGKGA 40-Li B2 Traduccion Del Manual De Instrucciones Originale página 67

• Do not use any cleaning agents or
solvents. This could damage the device
irreparably. Chemical substances may
attack the plastic parts of the device.
Service intervals
Carefully perform the maintenance tasks listed in the following table on a regular basis.
Regular servicing of your unit will extend the life of your equipment.
Additionally, you will achieve optimum cutting performance and prevent accidents.
Service intervals table
Machine part Action
Complete ma- Check condition, replace damaged
chine parts as needed
Accessible
Tighten
screws and nuts
Chain wheel Check, replace as needed
Check, apply oil, reground or replace 
Saw chain
Blade bar Check, rotate, clean, apply oil
Cutter head Check correct installation
Gears lubricating
Sharpening the cutting teeth
Have the saw chain sharpened by a spe-
cialist, or proceed in accordance with the
operating manual for your saw chain shar-
pening device. Sharpening a saw chain
requires some practice. Replacing the saw
chain is preferable in case of doubt.
Changing the saw chain
Never attach a new saw chain
onto worn teeth, or onto a dama-
ged or worn blade bar.
• Always keep the device clean. After
each use of the device, you must
- clean the blade
(with an oily cloth);
- oil the cutter bar
with an oil can/
spray.
Before each use After 10 hrs of use





1. Switch off the device and remove the
batteries.
2. Release the nut (
the chain wheel cover (
3. Remove the old saw chain (
The mounting and tensioning of the new
saw chain is described in the "Assembly -
Tensioning the saw chain" section.
Maintaining/turning the
blade bar
The blade bar has to be reversed every
8-10 operational hours in order to ensure
even wear.
GB MT


34) and remove
33).
1).
67