cecotec BONGO D20 Serie Manual De Instrucciones página 65

4. PRODUCT ASSEMBLY
Unfolding
1. Detach the retaining bracket and pull the stem upwards.
2. Raise the stem and move the folding lever to the closed position to lock the stem in place.
3. Adjust the brakes with the Allen key.
Folding Fig. 25
1. Press the blue plate to release the folding lever.
2. Move the folding lever.
3. Turn the folding lever downwards and then the stem.
4. Align the locking hook with the hole in the retaining bracket.
Assembly of the handlebar
1. Connect the male connection cord of the handlebar to the female cord of the stem. Make
sure the male and female ports are correctly aligned.
2. Insert the handlebar into the top of the stem and screw it in place.
Precaution:
Be careful not to damage the cord during the process.
Checking the screws
Some of the screws may loosen during delivery. Please check all screws and tighten them
before turning on the electric scooter.
5. OPERATION
5.1. Switch-on and driving Fig. 23
1. Hold down the power button for 2 seconds.
2. Step on the deck with one foot and use the other one to propel yourself forward.
3. Place both feet on the deck.
4. Press the accelerator with your right hand. The electric motor will deliver power when the
speed of the scooter is equal to or greater than 3 km/h.
5. Press the accelerator to increase the speed.
6. Push the brake lever to stop or to ride more slowly.
7. Get off the electric scooter only when you ride at a very low speed or when you are still.
8. Fold down the kickstand (15, Fig. 22) to park the electric scooter when not in use.
ENGLISH
BONGO SERIE D20
65