Changing Gear Oil - Yamaha F20A Manual Del Propietário

Tightening torque:
Refer to "SPECIFICATIONS" page 4-1.
4) Align the propeller nut with the pro-
peller shaft hole. Insert a new cotter
pin in the hole and bend the cotter pin
ends.
NOTE:
602053 If the propeller nut does not align with the
propeller shaft hole after tightening to the
specified torque, then tighten the nut fur-
ther to align it with the hole.
EMU00905

CHANGING GEAR OIL

w
8 Be sure the outboard is securely fas-
tened to the transom or a stable stand.
You could be severely injured if the out-
board falls on you.
8 Never get under the lower unit while it
is tilted, even when the tilt-support
lever is locked. Severe injury could
occur if the outboard accidentally falls.
1) Put the outboard in a vertical position
(not tilted).
2) Place a suitable container under the
000912
gear-case.
4-28
GB