Configuration; Valve System Address Assignment - Aventics DDL Instrucciones De Servicio

52 AVENTICS | DDL, DDL-E | 1987765499–BDL–001–AC

Configuration

See section 5.1.1
Setting the DDL
module address
See section 5.1.3
Setting the data length
for output data
7 Configuration
7.1 Valve system address
assignment
The bus coupler's DDL address from 1 to 14 determines
the position of the output data in the field bus connection
data area and also the position in the controller's address
area.
If the DDL address 0 is used, the output data area is
located behind the E/P converter data and in front of the
I/O module data.
The valve system takes up 1 to 4 bytes in the controller's
output area, according to the initial data length setup.
The allocation of valve position/coil/LED to output byte/
bit is shown in the following tables.