Bus System Configuration - Aventics PROFIBUS DP Instrucciones De Servicio

76 AVENTICS | PROFIBUS DP | R402003657–BAL–001–AG
Commissioning and operation
7.2

Bus system configuration

The description in this chapter refers to the software
IndraWorks, Version 06.02.99.0. IndraWorks also contains
online documentation which must be observed during
operation.
The configuration steps laid out in this section are superior to
the settings on the bus coupler which have already been
described (see "Making settings" on page 70) and are a part of
the entire system's bus master configuration.
The work being described here may only be carried out by
qualified electronics personnel and in compliance with the
operator's documentation on configuring the bus master as
well as applicable technical standards, directives, and
safety regulations.
Before starting configuration, the following steps must have
been carried out and completed on the:
W
You have assembled the bus coupler and the valve system
(see "Assembling the CL03/CL03-XL with PROFIBUS DP"
on page 63).
W
You have connected the bus coupler (see "Connecting the
module electrically" on page 65).
W
You have carried out the settings to the bus coupler
(see "Making settings" on page 70).
Configuration error
An incorrectly configured bus coupler will lead to
malfunctions in the system, which may lead to damage to the
system.
O
The configuration may only be carried out by qualified
electronics personnel.
NOTICE