Publicidad
Idiomas disponibles
Idiomas disponibles
EN
Fig. A. Select a program from the list, the screen will visualize the info shown on the side. The info visualized
in this screen are the following:
• Name of the program
• Number of phases forming the program.
In the example shown on the side, the program is made up of 4 phases and the corresponding buttons are
light blue color.
The "+" button indicates the first free phase and can be used to add an additional phase to the program.
The button "6" indicates a phase which is not used.
The total duration of a program.
Pressing the icon Back you go back to the list of programs.
Pressing the icon Home you go back to the Home page.
Fig. B. Pressing one among the phases that form the automatic program, the oven shows the scre-
en shown on the side.
In this screen you can see the cooking parameters of the selected phase:
• The drawing here above on the left side indicates the cooking mode (convection or steam).
• The temperature rectangular icon shows the real temperature and on a smaller scale the set temperature for
the selected phase.
This icon could visualize the Delta T parameter if you have configured this function for the control of cooking
chamber temperature.
• The rectangular icon for percentage of humidification and the corresponding set value. This value can go
from 0 to 99% in convection mode and it's always 99% (not to be modified) in steam mode.
• The rectangular icon for the time and the corresponding value. This icon could visualize the core probe pa-
rameter if this function has been configured to control cooking duration.
NOTE: besides the cooking parameters shown by the screen, on the control panel also the leds of eventual
additional functions selected, activated for the selected phase light on (reduced speed ventilation, autoreverse,
and open release valve).
Fig. C. When you press one among the phases of the program and then the button "see set" the
control panel shows the info of the upside picture.
•
The rectangular icons show only the selected values.
(the real cooking chamber temperature and eventually core probe temperature are not shown).
•
The leds of the buttons for the parameters used to control cooking (in the example on the side cooking
chamber temperature and time) flash.
•
The leds of the buttons for the additional functions activated in the selected phase (in the example here on
the side, low speed ventilation and open release valve) flash.
Fig. D. If instead of pressing one of the phases of the program, you press the first free phase ("+"),
you will see a message to confirm the addition of a new phase.
The instructions to add a new phase are on paragraph 5.2.
1.5 KG ROAST CHICKEN
Fig. A
Fig. C
12
Fig. B
ADD
NEW PHASE?
Fig. D
Publicidad
