Especificaciones generales
❏ Analog Input (1-48)
Connector
Phantom Power
Pad Switch
Gain Control
Peak Indicator
Signal Indicator
Insert (Pre AD converter)
Insert Switch
AD Converter
❏ Analog Input (ST IN1-4 [L,R])
Connector
Phantom Power
Gain Control
Peak Indicator
Signal Indicator
AD Converter
❏ Analog Input (2TR IN ANALOG1,2 [L,R])
Connector
XLR-3-31 Type (Balanced) x4
Gain Switch
+24 dBu (default) / +18 dBu
AD Converter
24bit linear, 128 times oversampling
❏ Digital Input (2TR IN DIGITAL1-3)
AES/EBU XLR-3-31 Type (Balanced) x2 (DIGITAL
Connector
IN 1,2)
SPDIF RCA PIN (DIGITAL IN 3)
Sampling Rate
On/Off by software control (1:3 and 3:1 maxi-
Converter
mum input to output sample rate ratio)
❏ Talkback Input
Connector
XLR-3-31 Type (Balanced)
Phantom Power
+48V DC is supplied by software control
Gain
50 dB fixed (pre level control)
AD Converter
24bit linear, 128 times oversampling
TALKBACK IN and selected INPUT1-48 can be
Talkback Select
used simultaneously
❏ Oscillator
Level
0 to –96dB (1dB step)
On/Off
Dedicated switch and software control
MODE: Sine Wave 1ch, Sine Wave 2ch, Pink
Waveform
Sine Waveform: 100Hz, 1kHz, 10kHz
Routing
MIX1-24, MATRIX1-8, STEREO A,B (L,R)
382
Manual de instrucciones de PM5D/PM5D-RH V2 / DSP5D
XLR-3-31 Type (Balanced) x48
PM5D:
+48V DC is supplied to Input by individual mechanical switch
PM5D-RH:
+48V DC is supplied to Input by individual software control
PM5D:
0/26 dB attenuation
PM5D:
44 dB detented
–60 dB to –16 dB (PAD=OFF), –34 to +10 dB (PAD=ON)
PM5D-RH:
72 dB by software control
–62 dB to 10 dB (1 dB step)
Red LED is lit when post HA level reaches 3 dB below clipping
Green LED is lit when post HA level reaches 14 dB below nominal
PM5D:
Out, In (TRS Balanced)
PM5D:
On/Off
24bit linear, 128 times oversampling
XLR-3-31 Type (Balanced) x8
PM5D-RH:
+48V DC is supplied to Input by individual software control
PM5D:
44 dB detented
–34 dB to +10 dB
PM5D-RH:
72 dB by software control
–62 dB to +10 dB (1 dB step)
Red LED is lit when post HA level reaches 3 dB below clipping
Green LED is lit when post HA level reaches 14 dB below nominal
24bit linear, 128 times oversampling
Noise, Burst Noise
❏ STEREO A,B [L,R], MIX1-24, MATRIX1-8
Connector
XLR-3-32 Type (Balanced)
DA Converter
24bit linear, 128 times oversampling
❏ MONITOR OUT [L,C,R], CUE OUT
Connector
XLR-3-32 Type (Balanced)
DA Converter
24bit linear, 128 times oversampling
Level Control
Analog potentiometer
❏ PHONES (x2)
Connector
TRS
Level Control
Analog potentiometer
❏ Digital Output (2TR OUT DIGITAL1-3)
AES/EBU XLR-3-32 Type (Balanced) x2 (DIGITAL
Connector
OUT 1,2)
SPDIF RCA PIN (DIGITAL OUT 3)
Sampling Rate
On/Off by software control (1:3 and 3:1 maxi-
Converter
mum input to output sample rate ratio)
Sección de referencia