❏ Analog Input Characteristics (DSP5D)
Input Terminals
GAIN
–62 dB
INPUT 1-48
+10 dB
–62 dB
ST IN 1-4 [L,R]
+10 dB
*1. Sensitivity is the lowest level that will produce an output of +4 dBu (1.23 V) or the nominal output level when the unit is set to maximum gain. (all faders
and level controls are maximum position.)
*2. XLR-3-31 type connectors are balanced. (1=GND, 2=HOT, 3=COLD)
*
In these specifications, 0 dBu = 0.775 Vrms.
*
All input AD converters are 24bit linear, 128 times (@48 kHz) oversampling.
*
+48V DC (phantom power) is supplied to INPUT (1-48) XLR type connectors via one master and each individual software switches.
❏ Analog Output Characteristics (PM5D, PM5D-RH)
Output
Actual Source
Terminals
Impedance
STEREO A,B [L,R]
75Ω
MONITOR OUT
75Ω
[L,R,C]
CUE OUT [L,R]
75Ω
MATRIX OUT 1-8
75Ω
MIX OUT 1-24
75Ω
INSERT OUT 1-48
150Ω
PHONES (x 2)
15Ω
*1. XLR-3-32 type connectors are balanced. (1=GND, 2=HOT, 3=COLD)
*2. Phone jacks are balanced. (Tip=HOT, Ring=COLD, Sleeve=GND)
*3. PHONES stereo phone jacks are unbalanced. (Tip=LEFT, Ring=RIGHT, Sleeve=GND)
*4. There are switches inside the body to preset the maximum output level.
*5. INSERT OUTs are only provided for PM5D.
*6. The position of the level control is 10 dB lowered from Max.
* In these specifications, 0 dBu = 0.775 Vrms.
* All output DA converters are 24bit, 128 times (@48 kHz) oversampling.
❏ Analog Output Characteristics (DSP5D)
Actual Source
Output Terminals
Impedance
OMNI OUT 1-24
75Ω
*1. XLR-3-32 type connectors are balanced. (1=GND, 2=HOT, 3=COLD)
*2. There are switches inside the body to preset the maximum output level.
*
In these specifications, 0 dBu = 0.775 Vrms.
*
All output DA converters are 24bit, 128 times (@48 kHz) oversampling.
Manual de instrucciones de PM5D/PM5D-RH V2 / DSP5D
Actual Load
For Use With
Impedance
Nominal
Sensitivity
–82 dBu
50-600Ω Mics
(61.6 µV)
3kΩ
&
–10 dBu
600Ω Lines
(245 mV)
–82 dBu
50-600Ω Mics
(61.6 µV)
3kΩ
&
–10 dBu
600Ω Lines
(245 mV)
For Use With
*4
GAIN SW
Nominal
+24 dB (default)
600Ω Lines
+18 dB
+24 dB (default)
600Ω Lines
+18 dB
+24 dB (default)
600Ω Lines
+18 dB
+24 dB (default)
600Ω Lines
+18 dB
+24 dB (default)
600Ω Lines
+18 dB
10kΩ Lines
—
8Ω Phones
—
40Ω Phones
For Use With
GAIN SW
Nominal
+24 dB
(default)
600Ω Lines
+18 dB
Input Level
Max. before
*1
Nominal
–62 dBu
–42 dBu
(0.616 mV)
(6.16 mV)
+10 dBu
+30 dBu
(2.45 V)
–62 dBu
–42 dBu
(0.616 mV)
(6.16 mV)
+10 dBu
+30 dBu
(2.45V)
Output Level
Nominal
Max. Before Clip
+4 dBu (1.23 V)
+24 dBu (12.28 V)
–2 dBu (616 mV)
+18 dBu (6.16 V)
+4 dBu (1.23 V)
+24 dBu (12.28 V)
–2 dBu (616 mV)
+18 dBu (6.16 V)
+4 dBu (1.23 V)
+24 dBu (12.28 V)
–2 dBu (616 mV)
+18 dBu (6.16 V)
+4 dBu (1.23 V)
+24 dBu (12.28 V)
–2 dBu (616 mV)
+18 dBu (6.16 V)
+4 dBu (1.23 V)
+24 dBu (12.28 V)
–2 dBu (616 mV)
+18 dBu (6.16 V)
+4 dBu (1.23 V)
+24 dBu (12.28 V)
*6
150 mW
75 mW
*6
150 mW
65 mW
Output Level
*2
Nominal
Max. before clip
+4 dBu
+24 dBu
(1.23 V)
(12.28 V)
–2 dBu
+18 dBu
(616 mV)
(6.16 V)
Sección de referencia
Connector
clip
XLR-3-31 type
*2
(Balanced)
(24.5 V)
XLR-3-31 type
*2
(Balanced)
(24.5 V)
Connector
XLR-3-32 Type
*1
(Balanced)
XLR-3-32 Type
*1
(Balanced)
XLR-3-32 Type
*1
(Balanced)
XLR-3-32 Type
*1
(Balanced)
XLR-3-32 Type
*1
(Balanced)
Phone Jack (TRS)
*2 *5
(Balanced)
Stereo Phone Jack
*3
(TRS) (Unbalanced)
Connector
*1
XLR-3-32 type (Balanced)
385