Entering Dimensions In The Motorcycle Programmes; Wheel Spin - Corghi EM 9250 CompactLine Manual De Uso

DETECTION OF PLANS BY POINTER LASERBLADE
(IF PRESENT)
Geometry data detection for real balancing plans for the ap-
plication of adhesive weights can be facilitated by the laser
line on the automatic detector lever.
To enable this line, it is necessary to press the button on the
automatic arm (A, Fig.15b).
The laser line remains visible inside the rim for 10 seconds,
15b
then, if necessary, press the button on the automatic arm again.
5. ENTERING DIMENSIONS
IN THE MOTORCYCLE
PROGRAMMES
The operations described below are valid if the
motorcycle setting (byke) has been activated in the
"vehicle type" set up.
- Fit the appropriate extension on the inner measur-
ing arm, specifically extension A on machines with
no weight holder or extension B on machines with
weight holder (Fig.16).
- To acquire the wheel dimensions, follow the instruc-
16
tions in the paragraph "Entering wheel dimensions".

6. WHEEL SPIN

UK
WITHOUT GUARD
Press the key on the display together with the button on the left side and hold
them down until the braking phase starts. If one of the two contacts, or both, is released
during the wheel start-up or reading phase, the message "A Cr" will appear and the brake
will be automatically activated.
CAUTION
Do not operate the machine if the safety device has been tampered with.
CAUTION
During machine use, personnel may not be present in the area enclosed by the sec-
tioning in Fig. 5a.
EM 9250 - EM 9250 C CompactLine Operator's manual 113