Other Messages - Corghi EM 9250 CompactLine Manual De Uso

• use the
• press the
E 27 Excessive braking time. If the problem persists, contact the technical support
centre.
E 28 Encoder counting error. If the error occurs frequently, call in the technical support
centre.
E 30 Wheel spin device failure. Switch off the machine and call in the technical support
centre.
E 32
The wheel balancer has been jolted during the reading phase. Repeat the wheel
spin.
E F0 Error in reading the 0 notch.
- This message indicates the valve of the wheel that must be brought to
OP.1
- This message indicates that the position of the valve must be moved
OP.2 180
- This message is displayed when the improvement obtained by optimi-
Out 2
- Press the
- Notice PREMATURE EXIT from the unbalance optimisation program.
Abo rt
- Press the
- Notice TYRE MOUNTING INVERSION ON THE RIM in the OP.5 phase
--I- -I--
- This message indicates that the operator is in the "positioning the weights
HId dEn
no no
- This message is displayed if the wheel is balanced on the outer side.
142
key.

20. OTHER MESSAGES

the 12 o'clock position during phases 1 and 5 of optimisation (OPt).
180° with respect to the previous position (12 o'clock).
sation is not sufficient.
key to exit the program or the
the optimisation phase.
key to confirm or the
programme.
of the programme.
If you do not want to (or cannot) carry out this operation, press the
key. the machine will provide the instructions to complete
the programme without inversion.
behind the spokes Hidden Weight" programme.
EM 9250 - EM 9250 C CompactLine Operator's manual
keys to search for GAU CAL
key to continue
key to remain in the