Publicidad
Step 7
Fasten the FRONT MOLDING (X) and BACK MOLDING (Y) to the TOP (G) in the
å
exact locations shown. Use twelve SILVER 1-1/8" FLAT HEAD SCREWS (10S).
IMPORTANT: Do not overtighten the SCREWS. The heads of the SCREWS
å
should be even with the surface of the MOLDINGS.
NOTE: The MOLDINGS will set in from the edges of the TOP.
å
Fasten the SHORT MOLDINGS (Z) to the TOP (G) as shown. Use six SILVER
å
1-1/8" FLAT HEAD SCREWS (10S). Do not completely tighten these SCREWS at
this time.
Now, be sure the pointed corners of all four MOLDINGS line up with each other.
å
Tighten the SCREWS in the SHORT MOLDINGS.
NOTE: Do not overtighten the SCREWS.
å
SILVER 1-1/8" FLAT HEAD SCREW
(18 used in this step)
Page 12
Finished surface
Z
X
10S
The large holes should be closer
to the BACK MOLDING (Y).
Y
G
109843
Finished surface
Z
www.sauder.com/services
Publicidad
