Publicidad
Step 21
To insert a large drawer into your unit, line up the EXTENSION SLIDES on the large drawer with the EXTENSION
å
RAILS on the unit and push the large drawer into the unit until the large drawer is fully inserted. The large drawer will push
in hard until it is all the way in, then it will slide in and out easier. Repeat this process to insert the KEYBOARD SHELF.
To insert the small drawers into your unit, tip the front of the small drawer down and drop the rollers on the small drawer
å
behind the rollers on the unit. Lift the front of the small drawer up and slide it into the unit.
NOTE: The DRAWER FRONTS may need adjustments. To adjust the DRAWER FRONTS, loosen the SCREWS that attach
å
the DRAWER FRONTS to the DRAWER BOX FRONTS. Make adjustments and tighten the SCREWS.
Insert a HOLE PLUG (11P) into any visible unused holes in the unit.
å
For long-term care and maintenance of your unit, you may touch up the edges with the TOUCH-UP PEN (9M).
å
NOTE: Please read the back pages of the instruction booklet for important safety information.
å
This completes assembly. Clean with your favorite furniture polish or a damp cloth. Wipe dry.
å
And to celebrate, why not share your success story?
Caution
THIS SAUDER UNIT HAS BEEN DESIGNED FOR THE WEIGHTS
SHOWN IN THIS STEP. EXCEEDING THESE RECOMMENDED
WEIGHTS COULD RESULT IN EXCESSIVE "SAGGING" OF THE
SHELF. EXTREME OVERLOADING COULD CAUSE FAILURE OF
THE SHELF AND POSSIBLE INJURY.
40 lbs.
The LOCK BRACKETS must
be on the drawers as shown.
Page 26
25 lbs.
40 lbs.
11P
109843
125 lbs.
15 lbs.
15 lbs.
40 lbs.
9M
www.sauder.com/services
Publicidad
