Publicidad
Step 13
Press the NOTCHED FILE GLIDES (21B) over the LARGE DRAWER SIDES (D360) on one of the drawers. Press a STRAIGHT
å
FILE GLIDE (2B) over one of the LARGE DRAWER BOX FRONTS (D332). The FILE GLIDES are necessary to hang fi les.
The drawers are designed to hold letter, legal, or European-size fi les. If you wish to hang legal or European-size fi les,
å
use the FILE CLIPS (13B) and a FILE ROD (17B). Insert the FILE ROD (17B) into each FILE CLIP and slide the FILE CLIPS
onto the NOTCHED FILE GLIDES (21B) as needed. Follow the diagram.
NOTE: The legal or European-size fi les will hang on the FILE ROD (17B) and the STRAIGHT FILE GLIDE (2B).
å
If you wish to hang letter-size fi les, hang the fi les on the NOTCHED FILE GLIDES (21B). If desired, the drawers can hold
å
both letter and legal or European-size fi les.
Insert a PULL MOUNT (78K) into one of the holes on a LARGE DRAWER FRONT (L). Insert one end of a PULL (77K)
å
into the hole in this PULL MOUNT. Insert the other end of the PULL into another PULL MOUNT and insert it into the
other hole in the LARGE DRAWER FRONT.
Now, fasten the PULL MOUNTS (with PULLS) to the LARGE DRAWER BOX FRONT (D332). Use a BLACK 1-1/8"
å
MACHINE SCREW (21S) for each PULL MOUNT.
NOTE: The LARGE DRAWER FRONT should overhang the bottom edge of the drawer about 1/2". If it does not overhang
å
the bottom edge, the DRAWER FRONT is on upside down.
Repeat this step for the other two large drawers.
å
21B
D360
2B
D332
78K
77K
Page 18
13B
D332
17B
21B
D360
78K
2B
D332
L
109843
21S
BLACK 1-1/8" MACHINE SCREW
(12 used in this step)
www.sauder.com/services
Publicidad
