Publicidad
Step 8
Separate the KEYBOARD SLIDES (DD) from the KEYBOARD RAILS (CC). To do this, fully extend the KEYBOARD
å
SLIDE and push the metal release in and pull the SLIDE from the RAIL so you have two separate parts. Be
prepared, the parts are greasy.
Fasten the KEYBOARD RAILS (CC) to the TOP (G) as shown. Use four BLACK 9/16" LARGE HEAD SCREWS (1S)
å
through the oblong holes in the KEYBOARD RAILS and into the exact holes shown in the TOP.
NOTE: Be sure to position each KEYBOARD RAIL as shown, with the open ends facing out. Follow the diagram
å
closely. Try to center the SCREWS in the oblong holes.
NOTE: The KEYBOARD SLIDES will be used later for the KEYBOARD DRAWER.
å
Push the metal release in and pull the SLIDE from the RAIL.
CC
Open end
www.sauder.com/services
DD
CC
BLACK 9/16" LARGE HEAD SCREW
CC
Y
G
1S
(4 used in this step)
109843
Page 13
Publicidad
