Publicidad
Step 3
Fasten the CABINET RIGHTS (40CA) and CABINET LEFTS (40CB) to the RIGHT END (A2) and
å
RIGHT UPRIGHT (C2). Use eight GOLD 5/16" FLAT HEAD SCREWS (3S) through holes #1 and #3.
Fasten two EXTENSION RAILS (45MA) to the RIGHT END (A2) and RIGHT UPRIGHT (C2). Use
å
four GOLD 5/16" FLAT HEAD SCREW (3S).
NOTE: For each EXTENSION RAIL, turn a SCREW into the hole shown in the enlarged diagram.
å
Then slide the inner cartridge of the EXTENSION RAIL in to fi nd the other hole that lines up with
the hole in the RIGHT END or RIGHT UPRIGHT. Turn a SCREW into this hole.
GOLD 5/16" FLAT HEAD SCREW
(12 used in this step)
Short edge with
TWIST-LOCK®
FASTENERS
2
1
1
Roller end
Finished edge
Page 8
3S
4
3
4
3
2
C2
1
2
3
2
4
3
4
109843
Roller end
Finished edge
1
A2
www.sauder.com/services
Publicidad
