Maintenance; General Maintenance - Skil JS820201 Manual Del Propietário

MAINTENANCE

WARNING
Service
WARNING
cause serious hazard. We recommend that all tool service be performed by a SKIL Service
Center or Authorized SKIL Service Station.

General Maintenance

WARNING
Periodically inspect the entire product for damaged, missing, or loose parts such as screws,
nuts, bolts, caps, etc. Securely tighten all fasteners and caps and do not operate this product
until all missing or damaged parts are replaced. Please contact customer service or an
authorized service center for assistance.
Retighten the Foot (Fig. 12)
If the foot-adjustment lever loosens during use,
set its tightness following the procedure below:
a. Place the foot-adjustment lever in the middle
position.
b. Loosen the locking screw counterclockwise
with a PH2 screwdriver.
c. Tighten the set screw finger tight
clockwise with a 4mm Allen key.
d. Tighten the locking screw clockwise with a
PH2 screwdriver.
e. Tighten the foot-adjustment lever.
Cleaning
WARNING
Ventilation openings and switch selectors must be kept clean and free of foreign matter. Do
not attempt to clean by inserting pointed objects through openings.
WARNING
ammonia and household detergents that contain ammonia.
Storage
Store the tool indoors in a place that is inaccessible to children. Keep away from corrosive
agents.
18
To avoid serious personal injury, always remove the battery pack
from the tool when cleaning or performing any maintenance.
Preventive maintenance performed by unauthorized personnel may
result in misplacing internal wires and components, which could
When servicing, use only identical replacement parts. Use of any
other parts could create a hazard or cause product damage.
The tool may be cleaned most effectively with compressed dry air. Always
wear safety goggles when cleaning tools with compressed air.
Certain cleaning agents and solvents damage plastic parts. Some of
these are: gasoline, carbon tetrachloride, chlorinated cleaning solvents,
Fig. 12
Set Screw Locking
Screw