Publicidad
Idiomas disponibles
Idiomas disponibles
3. Battery charger
The MD5KVR uses a rechargeable LiFePO4 12 V - 6000 mAh battery.
Charging procedure:
Check if the MD5KVR is turned-off and connect it to the mains (AC
adapter).
The charging indicator ( ) will turn on red and will
remain that way until the battery is totally charged. Then the light will
remain green and keep in that way until the MD5KVR is disconnected
of the mains.
Use only the AC Adapter provided by the manufacturer. The use of any other
AC Adapter may compromise the equipment safety.
This equipment uses a smart battery with overcurrent and overload protection.
Therefore, it may occur that in situations of high voltage sparking, the battery will
protect the equipment disarming the system. To reassemble the system is
necessary charge the battery for a few seconds.
Perform a full charge cycle before using the equipment for the first time, or
after a period without using the equipment (The battery loses some of its
charge being stored).
The rechargeable battery does not have "memory effect" and there are no
restrictions to start charging it as many times as is needed. Charge the battery
before left the equipment in storage and don't let pass more than 30 days without
recharge.
IMPORTANT: If, during the battery charge, the equipment is turned ON, the charge
will be momentarily interrupted, returning to the charge process once the
equipment is turned OFF.
14
Publicidad
