Publicidad
Idiomas disponibles
Idiomas disponibles
10. Printer
In order to enable the printing function press key. Measured values
will be printed each 15 seconds. Printing may be started or stopped at
any time during the test. However, it is convenient to turn the printer on
before starting the test in order to print it complete, including the heading.
ATTENTION: Don't pull the paper. The printer can be easily damaged.
This printer uses 57 mm-wide thermal paper, which comes in a 30 mm-
diameter reel.
Precautions
• Perform the procedures below with the equipment turned off.
• Disconnect the equipment from the mains supply and remove
the power cord.
• Disconnect the test leads.
Pull the lever located on the lid.
Insert the paper reel as shown in the figure.
Keep the tip of the paper out of the printer and close the lid.
11. Cleaning
The panel, terminals and connectors of the equipment must stay dry and
clean. Cleaning should be made using a wet cloth in water and a soft
detergent or isopropyl alcohol (be sure that the products to be used for
cleaning does not affect plastic goods).
46
Publicidad
