Publicidad
Idiomas disponibles
Idiomas disponibles
6. Performing tests
OBS.: If the resistance to be measured exceeds the maximum limit of the
selected voltage this message will be displayed: R > XXXΩ.
(see 12. Technical Specifications, pg. 47)
ATTENTION: Please, never connect or disconnect the test leads
with the equipment under operation or while the High Voltage led (
connections,
disconnected and with discharged potentials (High Voltage led
6.1. Manual Testing
• Access the device's MENU using the
• Use the control
• Use the control
• Set the test parameters (see Setting the measurement modes, item
5.2.1. Manual mode, pg. 19).
The test voltage is the only parameter that can be modified during
the test.
) is on. If there is a need to modify the
this
should
be
off).
, select MODE SELECTION and press
MODE SELECTION
SETUP TEST
LANGUAGE
, select MANUAL TEST and press
=
SETUP TEST========
MANUAL TEST
TEMPO
RIZED TEST
STEP VOLTAGE TEST
36
done
with
the
button.
.
=
equipment
.
Publicidad
