Publicidad
Idiomas disponibles
Idiomas disponibles
• Maximum voltage
(See 5.2.5.2, pg. 25)
• Dwell time
Use the control
the time in minutes and press
and press
to confirm or
5.2.5. Common parameters
The following parameters are present in almost all measuring modes,
however each measurement mode stores its own setting value.
5.2.5.1. Minimum resistance (pass / fail mode)
• This mode allows you to set a minimum resistance value and perform
pass / fail test. Use the control
option and press
confirm by pressing
Use the
, select a value from 1 to 999 and press
, select the unit (kΩ, MΩ, GΩ or TΩ) and confirm with the
, select DWELL TIME and press
. Use
to cancel.
DWELL TIME
1:00
MM:SS
. Use the control
.
=ENABLE MIN RES=====
ON
.
OFF
MINIM
UM R
ESIST
__1 T
24
. Use
to set the time in seconds
, select the MINIMUM RESIST.
, select the ON option and
button. With the
ANCE
to set
.
Publicidad
