Zhermack ELITE MIX Manual Del Usuario página 116

CONNECTING UP TO THE POWER SUPPLY
6.4
The user must provide a power connection with relative socket near the machine installation point.
The user must also install an adequate electrical circuit breaker upstream from the socket as well as
efficacious overload/indirect contact safety devices. Connection is effected via the safety plug (16A, in
compliance with European standards) at the end of the power lead: this must be inserted in the mains
socket.
When connecting check:
• that mains voltage and frequency are as indicated on the identification plate (incorrect power
supply voltage may damage the machine);
• that the mains supply has a proper, efficient earth connection.
It is forbidden to tamper with the power lead and its plug. When replacing them
owing to damage and/or wear please contact an Authorised Service Centre.
A proper earth connection is compulsory. Should it temporarily be necessary
to use an extension lead the latter must comply with the standards in force
in the country of use.
STARTING UP THE MACHINE
6.5
1
Figure
The examples shown in the following illustrations refer to a wall-mounted elite
mix.
6
2
Figure
Failure to observe any of the above machine installation instructions may lead to
malfunctions and render the warranty null and void.
116 of 264
Fig. 1: Make the holes with the aid of the supplied
template and position the vacuum mixer correctly on
the wall (or on the workbench if you have a stand); see
section 6.3.1.
Fig. 2: Insert the connector in the socket (6) near the
main switch, connect the mixer plug (9) to the mains
power socket.
Always observe the information given in section 6.4.
7
MAINTENANCE AND USE MANUAL
EN
ELite mix