Publicidad
Idiomas disponibles
Idiomas disponibles
Espresso machine Use instructions
The appliance is equipped with a thick aluminum boiler that heats fast and has excellent steam, hot
water capacity.
3.Removable drip tray
The drip tray is removable for easy cleaning.
4.Detachable water tank
The 1.5L transparent water tank with hinged lid is detachable for easy cleaning and refilling.
5.Safety system
The appliance is equipped with pressure relief valve, thermal fuse and dual thermostat to prevent
from overheating and overpressure.
6.Froth enhancing function
The appliance is equipped with a froth-aid device, enjoy abundant milk froth for cappuccino within
minutes.
Before using for the first time
1.Remove all packaging.
2.Wind excess cable around the storage slot on the bottom of the machine.
3.Wash the parts, please refer to "Cleaning".
4.Flush the machine through with clean water in the following steps:
a)Make sure the all buttons are in the off position and that the steam/hot water knob is closed by
turning clockwise.
b)Lift out the tank, draw up the lid and fill with cold water up to the MAX level marked. Alternatively
draw up the lid and fill the tank whilst in position on the espresso machine.
We recommend using filtered water as it produces better coffee and reduces limescale, never use
fizzy water.
c)Refit the tank, make sure that it is correctly located and apply light pressure if necessary to ensure
the valve at the bottom of the tank connects with the water inlet of the machine.
It is normal for water to remain in the compartment under the tank, this can be done using a sponge.
d)Swing out the steam/hot water nozzle then attach the filter holder to the machine by positioning it
under the boiler outlet and turning to the right, place a bowl underneath.
e)Plug in the mains supply, Press down the On/Off button then the power light will glow.
f)Immediately press down the coffee/hot water button and wait until water drip from the filter holder.
This means the boiler has been filled with water.
Note: You have to operate this step as soon as possible, otherwise the boiler will be dry-boiled.
Important: You can not brew espresso if you have not flushed the machine at first, the flushing cycle
causes the boiler to fill with water. If you have not used the machine for a few days, you have to flush
it with fresh water before you use it again.
Preheating the espresso machine
To ensure your espresso coffee is brewed at the right temperature it is essential that the coffee
appliance is preheated.
1.Check that the steam/hot water knob is firmly closed (turn clockwise) and that there is water in
the tank.
2.Put a jug under the steam/hot water nozzle.
3.Fit the desired filter into the filter holder (without coffee) and attach to the machine by positioning
it under the boiler outlet and turning to the right, ensure is it firmly located.
4.Position two cups under the filter holder, if you use the same cup that the coffee will be served
17
Publicidad
