Beper Bellavita 90.511 Manual De Instrucciones página 22

Espresso machine Use instructions
PROBLEM
Espresso coffee does not come
out of the machine.
Espresso coffee drips from the ed-
ges of the filter holder, instead of
from the holes.
The espresso coffee is cold
The pump is too noisy.
The coffee cream is light in colour
and is dispensed too quickly.
POSSIBLE CAUSE
The coffee is damp.
Pressed the coffee too firmly into
the filter.
The holes in the filter holder spouts
are blocked.
The boiler outlet is blocked.
The tank is incorrectly fitted and
the valve at the bottom is not open.
The holes in the crema device are
blocked.
The filter holder is incorrectly atta-
ched to the machine.
Some powder remained on the
side of boiler outlet or the gasket
for boiler outlet.
The holes in the filter holder spouts
are blocked.
The gasket of the espresso boiler
has lost its elasticity.
Preheating the machine was not
carried out.
The cups were not preheated.
The Ready light was not glowing
when starting to brew coffee.
The water tank is empty.
The tank is incorrectly fitted and
the valve in the bottom is not open.
The ground coffee has not been
pressed enough.
Insufficient ground coffee has
been used.
Too much coffee has been dispen-
sed.
The coffee used is unsuitable.
22
SOLUTION
Check that you are using ground
coffee suitable for espresso ma-
kers.
Press the coffee more lightly in the
filter and change the grind if neces-
sary.
Clean the holes in the spouts.
Clean the boiler outlet as indicated
in the chapter 'cleaning'.
Press the tank lightly so as to open
the valve at the bottom.
Dismantle the crema device and
clean parts thoroughly. See 'Cle-
aning'.
Refit the filter holder, making sure
it is located correctly and turn to
the right.
Remove the powder from boiler
outlet and the gasket.
Clean the holes in the spouts.
Get the gasket replaced to con-
tact the nearest authorized service
agent
Follow instructions on 'preheating
the espresso machine'.
Preheat the cups by rinsing with
hot water or placing on the cup
warming tray.
Wait until the Ready light glows be-
fore starting to brew coffee..
Fill the tank with water.
Press the tank lightly so as to open
the valve at the bottom.
Press the coffee more firmly.
Increase the quantity of coffee as 7
grams (1 full spoon) per cup.
Decrease the quantity of coffee di-
spensed into the cup(s).
Use the coffee suitable for espres-
so machines.