Publicidad
Idiomas disponibles
Idiomas disponibles
Espresso machine Use instructions
To boil water for other drinks, tea, e.g.
1.Make sure all buttons are in the off position.
2.Check that there is water in the tank.
3.Press down the On/Off button.
4.Position a container under the steam/hot water nozzle.
5.When the ready light glows, turn the steam/hot water knob in an anti-clockwise direction then
press down the coffee/hot water button, hot water will come out of the steam nozzle.
6.Release the coffee/hot water button to off position to stop the flow of hot water, then turn the ste-
am/hot water knob in a clockwise direction to close.
NOTE: 1. Do not spout hot water from the steam nozzle for longer than 20 seconds in one operation.
2. To avoid any risk of scald, you have to use a handled container with enough depth, because
strong steam and rapid hot water will come out of the steam/hot water nozzle, especially at the be-
ginning of the above step 5.
Cleaning
1.Never immerse the cord, plug, or appliance itself in water or other liquids.
2.Always unplug the machine and make sure cool down before you clean it.
3.Don't wash parts in the dishwasher.
Tank, lid, filter holder
Wash, rinse and allow to dry In order to prevent filter holder was oxidized, it must be dry
Filter (one and two cup version)
1)Wash and dry after every use.
2)After approximately every 100 uses dismantle and clean more thoroughly as described below:
Remove the metal filter from the filter holder. Clean the filter in hot water using a brush, make sure
the holes in the filter are not blocked, if necessary clean with a pin. Dry the parts then reassemble,
make sure the parts are correctly assembled.
Steam/hot water nozzle
1)Prior to cleaning allow some hot water to flow out of the nozzle(see 'To boil water for other drinks')
then unplug and allow to cool before proceeding.
2)Pull out the rubber tube downwards, then wash thoroughly. Check that the hole in the nozzle is not
blocked, if necessary unblock them with a pin.
3)Revolve the rubber tube onto the nozzle.
Cup stand, drip tray
Empty the drip tray regularly, you'll know when it is full, the red float in the drip tray will rise and
become visible in the hole on the cup stand. Wash then dry.
Boiler outlet
Wipe away any coffee grounds from this area, at lease twice a year carry out the following proce-
dure.
1)using a screwdriver, unscrew the screw that holds the outlet of the boiler in place
2)Clean the boiler area with a damp cloth.
3)Clean the removed outlet thoroughly in hot soapy water using a brush , rinse thoroughly, make
sure the holes are not blocked, and if necessary use a pin to clean.
4)Reverse the above procedure to re-fit to the outlet, make sure the parts are correctly assembled.
20
Publicidad
