MAXA HCA1 22 Manual Usuario página 36

I. 2.3 CONTROLS SUPPLIED AS STANDARD
• Remote control R51 with batteries. For instructions, please refer to paragraph I.3.1.
I. 2.4 CONTROLS SUPPLIED LOOSE
• Wire control with LCD display and 10 keys, for the manual regulation of all the appliance functions on the basis of
the selected ambient temperature. The wire control is designed to be wall-mounted. For instructions on how to install
and use the wire control, please refer to the instructions for use provided with the same.
I. 3 INSTRUCTIONS FOR USE
The following operations can be carried out using the remote control and/or the wire control see the instructions for
use provided with the same:
• Switching the unit on/off,
• Selection of the three fan speeds.
• Adjusting the thermostat and maintaining the desired ambient temperature.
• Switching between the cooling/heating operating cycle.
The unit panel houses a number of indicators which provide information on the unit status or alarm signals. If the
remote control and/or wire control are temporarily unavailable, they can be used to operate the unit in manual mode
using the MANUAL key.
I. 3.1 REMOTE CONTROL R51
The remote control can be used to set and display all the unit operating parameters, facilitating the all programming
operations. The remote control is powered by two 1.5V AAA R03 batteries.
IMPORTANT!
It is advisable to test the remote control in order to establish its reception zone.
36
。
SETTIN G TEMP( )
( C)
FAN
AUTO
HIGH
COOL
MED
DRY
LOW
HEAT
TEMP
ON/OFF
MODE
FAN SPEED
SWING ECONOMY TIMER ON
TIMER OFF
SWING
RESE T LOCK
AIR
DIRECTION