MAXA HCA1 22 Manual Usuario página 38

I. 3.2 SWITCHING THE UNIT ON AND OFF
ON/OFF
Press the ON/OFF key to switch the unit on or off.
When switching from ON to OFF the operating mode is interrupted and current time delays are cancelled, while the
appliance and fan operating modes and the set temperature value are memorised. When switching from OFF to ON,
the machine automatically restores all the operating modes memorised before it was switched off.
When the unit is on, the unit on symbol appears on the display.
The presence of this symbol on the display indicates that the remote control is transmitting the settings to unit ▲.
I. 3.3 SETTING THE OPERATING MODE
By pressing the Mode key several times it is possible to change the unit operating mode. The selected operating
mode symbol appears on the display.
AUTO: automatic mode.
COOL: cooling mode.
DRY: dehumidification mode.
HEAT: heating mode.
FAN: fan only mode.
When the automatic programme AUTO is selected, the unit may operate in COOLING or HEATING mode depending
on the temperature difference in place between the ambient temperature and the temperature selected on the remote
control. When the cooling programme COOL is selected, the unit operates with a free temperature setting, lowering
the ambient temperature. When the dehumidification programme DRY is selected, the unit operates with a free
temperature setting, progressively lowering the ambient temperature and humidity. When the dehumidification
programme DRY is in operation, the FAN SPEED button cannot be used. When the heating programme HEAT is
selected, the unit operates with a free temperature setting, raising the ambient temperature. When the fan programme
FAN is selected, the unit operates without temperature settings, simply blowing air through the environment.
IMPORTANT!
- The unit fan stops when the set temperature is reached and is then automatically reactivated at minimum speed to
prevent air stratification phenomena in the vicinity of the appliance.
- When the COOL DRY mode is selected, the fan may not start up straight away because the ANTI-HEATING mode
is present (see paragraph I.4.6.1). When the HEAT mode is selected, the fan may not start up straight away because
the ANTI-COOLING mode is present (see paragraph I.4.6.2).
I. 3.4 ECONOMY MODE
ECONOMY
This function is not available in the units.
I. 3.5 SETTING THE DESIRED TEMPERATURE
▲and▼ by pressing these keys in the AUTO, COOL, DRY and HEAT modes, it is possible to increase or reduce the
desired temperature between 17°C and 30°C. The display shows the selected temperature.
I. 3.6 SETTING THE LOUVER
In order to obtain optimal air distribution, adjust the motorised louver, making sure that the air flow is not directly
pointed at anyone. For the motorised louver, proceed as follows:
By pressing the AIR DIRECTION key several times it is possible to modify the position of the
AIR DIRECTION
deflector.
By pressing the SWING key it is possible to activate continuous louver swing mode.
SWING
DANGER!
Moving the motorised louver manually when the unit is on could cause operating problems or damage the adjustment
system.
I. 3.7 SETTING THE FAN
By pressing the FAN SPEED key several times it is possible to adjust the fan speed between the three available
speeds, or to activate the AUTO mode. The operating mode appears on the display:
AUTO: automatic speed operation
LOW: minimum speed operation
MED: medium speed operation
HIGH: high speed operation
38