Ryobi RM480e Manual Del Usuario página 11

Do not dispose of waste batteries,
waste electrical and electronic
equipment as unsorted municipal
waste. Waste batteries and
waste electrical and electronic
equipment must be collected
separately. Waste batteries, waste
accumulators, and light sources
have to be removed from the
equipment. Check with your local
authority or retailer for recycling
advice and collection point.
According to local regulations,
retailers may have an obligation
to take back waste batteries and
waste electrical and electronic
equipment free of charge. Your
contribution to the reuse and
recycling of waste batteries and
waste electrical and electronic
equipment helps to reduce the
demand of raw materials. Waste
batteries, in particular containing
lithium, and waste electrical and
electronic equipment contain
valuable and recyclable materials,
which can adversely impact the
environment and the human
health if not disposed of in an
environmentally compatible
manner. Delete personal data from
waste equipment, if any.
SYMBOLS IN THIS MANUAL
Parts or accessories sold
separately
Note
Warning
UNPACKING
See page 260-261.
■ Remove and set aside all accessible packaging
and wrap from the unit and parts. Do not discard the
packing material until you have carefully inspected and
satisfactorily operated the product.
■ Inspect the product carefully to ensure that no breakage
or damage occurred during shipping.
■ If any parts are damaged or missing, contact an
authorised service centre. Do not assemble the
product until the parts are replaced with new original
manufacturer's parts. Assembling the product with
damaged, missing, or incorrect parts could result in
serious personal injury.
■ If any parts are already assembled to the product when
you unpack it, verify that the part is assembled correctly,
is properly tightened, and is torqued correctly (where
applicable) before proceeding to the next assembly step.
The use of a product that may have been improperly
assembled could result in serious personal injury.
ASSEMBLY
See page 264-266.
■ The product should be assembled while positioned on
the bottom frame. When assembly is complete, set the
cutting deck to its maximum height, then position a ramp
next to the frame bottom, and slowly and carefully drive
the product off the frame.
■ Strictly adhere to all
specifications. Failure to do so could cause serious
personal injury.
■ To prevent accidental starting that could cause serious
personal injury, always remove the start key from the
product when assembling the parts.
■ Use care when driving the product off of the frame, and
step on the brake pedal as needed to control the speed.
The product freely rolls if it is moved on an inclined
surface without stepping on the brake pedal or engaging
the parking brake. Failure to follow these instructions
can result in loss of control and result in death, serious
personal injury, or property damage.
■ If no ramp is available, slowly and carefully drive the
product off the frame in reverse while looking down and
behind. Driving the product off the frame in the forward
direction without a ramp can cause damage to the
cutting deck.
torque wrench tightening
11
Original Instructions
EN
ES
IT
NL
PT
RU
PL
CS
HU
RO
LV
LT
ET
HR
SL
SK
BG
UK
TR