15.4.3
Temperature Mode
Press the Function Key 3. to select the temperature. The preset temperature stage
"120°C" is selected and the device turns on.
With the + / - keys, you can change the settings at any time in a range from 60 –
240°C. (Temperature stages: 60, 70, 80, 90, 100, 120, 140, 160, 180, 200, 220 and
240°C).
Please note that the two functions of level and temperature can be chosen as
alternative . You can either work with the power levels or with the temperature
stages. The most recently selected function is active.
The temperature is measured by a sensor below the glass ceramic plate, therefore
the displayed temperature can deviate from the temperature in the pot.
Please note
► In case of grilling or cooking deep fry food we would advise you to use the function
"Temperature" as in this case you can use temperatures up to 240°C. Otherwise the
overheating protection "E05" will be activated.
► When one hotplate works with 180-240°C then the other hotplate automatically
switches to 0 °C.
► When one hotplate works with 180-240°C then the level of other hotplate automatically
switches to level 0.
15.4.4
Powersharing Mode
If both induction fields are operated, the boards will share over power sharing
function levels as follows:
left
12
11
right
0
0
15.4.5
Timer
Timer Function. Press the button Timer 2.
select the operating time in 1-minute intervals (up to max. 180 minutes).
Once the time is up, an acoustic signal sounds and the device automatically goes
into standby mode.
Please note
► During timer operation, you can change the duration at any time with the +/- keys. With
the memory function of the device, the power stage or temperature settings remain
unchanged here.
10
9
8
7
6
7
8
9
10
10
5
4
3
2
1
10
10
10
10
10
With the +/- keys, you can now
45