Publicidad
Idiomas disponibles
Idiomas disponibles
5. ATTACHMENT SETTING UP
5.1- Assemble Engine with shaft tube
1. Put engine and shaft tube on ground and start assembly. Fig.1
2. Attach clutch to engine and fasten 4pcs of screws tightly to prevent
loosing.
5.2- Handle
1. To joint loop handle with main pipe evenly.
2. Adjust loop handle joint to most comfortable position for user.
3. Lock tight bolts.
5.3- Throttle wire mounting
1. Pass the throttle wire through adjust screw. Fig. 3
2. Move the carburetor swivel toward the attachment.
3. Fit the tip (thick portion) of the throttle wire into the ground hole in the swivel.
4. Fit the tip of the throttle wire from the throttle trigger to cut in the tip of the throttle wire from the
engine. Fig. 4
5. Close the cover so that the arrow mark is set toward the lever by holding the joint of 2 throttle wires
9
Publicidad
