Publicidad
Idiomas disponibles
Idiomas disponibles
Adjustment of Chain Oil Supply
The chain oil quantity discharges through the lubrication system is
factory-adjusted to medium. Adjust the flow in accordance with the operat-
ing condition.
1. Loosen the fixing screw one turn. Fig. 19
2. Turn the adjusting screw clockwise to decrease the quantity and counter-
clockwise to increase the flow. Fig. 20
3. After adjustments have been made, tighten fixing screw. Fig. 21
Remarks: Do not try to turn the screw clockwise beyond 1 turn from it's most counterclockwise position
or the maximum quantity discharged position.
NOTE
When you host the proper position of the screw, start with the most counterclockwise position.
8.4- Pruning
The Pole saw is designed for light to medium trimming of limbs and branches up to 203mm (8in.) in
diameter. Follow these tips for successful operation.
1. Check direction of branch will fall.
2. Plan retreat path from falling branch as cut branches might bounce when striking ground.
3. Long branches should be removed in several pieces.
4. Do not stand directly beneath branch being cut.
5. When ready to cut: Hold "cutting shoe" against branch. This will prevent whipping of the branch. DO
NOT use back and forth sawing action.
6. Look out for branch immediately behind the branch being cut. If saw chain hits rear branch damage
to saw chain and guide bar may occur.
7. Accelerate to full throttle
8. Apply cutting pressure.
9. Ease cutting pressure when nearing end of cut to maintain control.
17
Publicidad
