Publicidad
Idiomas disponibles
Idiomas disponibles
5.4- Lead wire
Connect 2 lead wires from the throttle trigger to the corresponding 2 wires
from the engine. Fig. 5
5.5- Wearing shoulder harness
The shoulder harness has a quick release mechanism, so that you can release the
harness instantly in an emergency.
1. Pull the harness grip upward to separate the hook from the harness so that
the harness is separated from the trimmer. Fig. 6
2. Pass your arms through the straps as if putting on a coat. Buckle the harness
at the front of your body. Set the shoulder pads properly.
3. When reconnecting the harness to the hedge trimmer attachment, its nec-
essary to attach the hook ring to bracket first and insert the grip into hole in
bracket Fig. 8
5.6- Preparation for cutting attachments
1. Loosen knob first.
2. Pull up pin.
3. Insert attachment shaft into coupler until the pin enters the hole
of attachment
4. Fasten Knob.
PRECAUTION
Publicidad
