Publicidad
Idiomas disponibles
Idiomas disponibles
6. CUTTING ATTACHMENT - Brush Cutter
6.1- Cutting attachment guard mounting
1. Insert screws into the taped holes on the additional guard and tighten the
nuts with washers from guard.
2. Set the holder guard, cover bracket in this order as shown
3. Insert screws from over the cover bracket into the holes through spring
washers and then tighten the screws
6.2- Mounting for Nylon-cutting attachment
1. Match the hole in the side of the cutting attachment guard with the hole in the side of the gear hous-
ing.
2. Screw the nylon line cutting attachment securely. Fig. 9
3. Mount the shaft nut on the nylon cutting attachment head.
4. Remove the nylon line cutting attachment tightening nut and cup washer from gear housing.
5. Insert the upper clamp and lower clamp into the
gear housing.
6. Then insert an Allen wrench 4 mm in the holes to
stop moving the clamp. Fig. 10
7. Tighten the nylon cutting head counterclockwise
manually into the gear housing.
8. Remove the Allen wrench 4 mm.
6.3- Mounting for Metal Blade cutting attachment
1. Match the hole in the side of the cutting attachment guard with the hole in the side of the gear hous-
ing.
2. Screw the blade cutting attachment securely. Fig. 10
3. Mount the shaft nut on the blade cutting attachment head.
4. Remove the blade cutting attachment tightening nut and cup washer from gear housing.
5. Insert the upper clamp and lower clamp into the gear housing.
11
Publicidad
