Publicidad
Idiomas disponibles
Idiomas disponibles
11. Continuously check the working area for wires, cord, glass or other foreign objects what could get
caught in the cutter blades.
12. Confirm that the cutter blades are in rapid motion before starting to cut.
13. Always grip the pole hedge trimmer with both hands and maintain a firm grip when working with the
machine.
14. To assure optimal control over the pole hedge trimmer, always completely wrap your hands around
the handles.
15. Note that the cutter blades will remain in motion for up to two seconds after the throttle lever has
been released.
16. Do not cut with the pole hedge trimmer at low engine speed.
17. The speed of the cutter blades can not be adjusted properly with the throttle lever when the engine
is running at low speed.
18. To trim the top surface of a hedge, first align the cutting tool at an angle of 15~30 degree in the
cutting direction and keep the pole hedge trimmer in a horizontal position. Then start trimming the
hedge using a swinging movement, much like drawing circle segments with the hedge trimmer shaft.
19. To trim the sides of a hedge, align the blades parallel to the surface to be cut and start trimming with
semi-circular upward movements.
20. Pay attention when trimming a hedge that has grown along a fence. Be especially careful not to
allow the cutter blades from coming into contact with solid matter such as a metal fence. Cutting
into solid matter such as metal, stone, concrete or thick wood may damage the blades and/or cause
overall break-down of the machine.
21. Do not use the pole hedge trimmer over an extended period of time, as a general rule, for every 50
minutes of operation, take a 10~20 minutes rest.
22. If the cutter blades come into contact with stones or other solid objects, stop the engine immedi-
ately and check the blades for damage. Replace the blades if damaged.
23. If the pole hedge cutter develops a problem during operation, immediately stop the engine. Do not
use the machine again until the problem has been recognized and solved.
24. Always do your utmost to keep pollution and noise emissions as low as possible when operating the
pole hedge trimmer. Pay special attention to correct carburetor adjustment and accurate gasoline/
oil mixture.
25. If thick branches get jammed in the cutter blades, immediately stop the engine, lay the equipment
on the ground and remove the obstruction. Check the blades for damage before using the machine
again.
Publicidad
