Husqvarna 545G Mark II Manual Del Usuario página 21

7. Continue to cut more into the tree until the tree/
branch bends and the tension is released.
8. Cut the tree/branch from the opposite side of the
bend, after the tension is released.
To use the product in cold weather
CAUTION:
cause operation problems. Risk of too low
engine temperature or ice on the air filter
and the carburetor.
1. Clothe a part of the air intake on the starter. This
increases the engine temperature.
2. For temperatures below -5°C/23°F or in conditions
with snow, a winter cover is available. Assemble the
winter cover on the starter housing. The winter cover
decreases the flow of cool air and keeps snow away
from the carburetor space.
Introduction
WARNING:
safety chapter before you do maintenance
on the product.
Maintenance schedule
Daily maintenance
Clean the external parts of the prod-
uct and make sure that there is no oil
on the handles.
544 - 011 - 09.11.2023
Snow and cold weather can
Maintenance
Read and understand the
Weekly maintenance
Clean the cooling system. Refer to
To clean the cooling system on page
32 .
Note:
Part number for winter cover: 595 96 76-01
CAUTION:
cover if the temperature increases above
-5°C/23°F. Risk of too high engine
temperature and damage to the engine.
Heated handles (545G Mark II, 550XPG Mark
II, 550XPG Mark II TrioBrake)
The product has heated front and rear handles. The
electrical heating coils are powered by a generator.
Push the switch in the direction of the arrow to engage
the function. Push the switch in the opposite direction to
disengage the function.
Electrical carburetor heating (545G Mark II,
550XPG Mark II, 550XPG Mark II TrioBrake)
Adjustment of the carburetor heating is done electrically
through a thermostat. This keeps the correct carburetor
temperature and prevents ice in the carburetor.
Monthly maintenance
Do a check of the brake band. Refer
To do a check of the brake band
to
on page 23 .
Remove the winter
21