Husqvarna 545G Mark II Manual Del Usuario página 31

To do a check of the guide bar
1. Make sure that the oil channel is not blocked. Clean
if it is necessary.
2. Examine if there are burrs on the edges of the guide
bar. Remove the burrs using a file.
3. Clean the groove in the guide bar.
4. Examine the groove in the guide bar for wear.
Replace the guide bar if it is necessary.
5. Examine if the guide bar tip is rough or very worn.
6. Make sure that the bar tip sprocket turns freely and
that the lubricating hole in the bar tip sprocket is not
blocked. Clean and lubricate if it is necessary.
544 - 011 - 09.11.2023
7. Turn the guide bar daily to extend its life cycle.
To do maintenance on the fuel tank
and the chain oil tank
• Drain and clean the fuel tank and the chain oil tank
regularly.
• Replace the fuel filter yearly or more frequently if
necessary.
CAUTION:
causes malfunction.
To adjust the chain oil flow
WARNING:
make adjustments to the oil pump.
1. Turn the adjustment screw for the oil pump. Use a
screwdriver or combination wrench.
a) Turn the adjustment screw clockwise to decrease
the chain oil flow.
b) Turn the adjustment screw counterclockwise to
increase the chain oil flow.
Recommended settings for the oil pump
• Guide bar length 38-46 cm/15-18 in: Medium flow
• Guide bar length 50-71 cm/20-28 in: Maximum flow
Air cleaning system
™
AirInjection is a centrifugal air cleaning system that
removes dust and dirt before the particles are caught by
Contamination in the tanks
Stop the engine before you
+ –
31