Husqvarna 545G Mark II Manual Del Usuario página 35

CSA Z62.3-11 (R2016) (Chainsaw kickback), when
equipped with the below listed saw chain and guide bar
combination(s).
Note:
Other chainsaw models may not meet the
kickback requirements when equipped with the listed
guide bar and saw chain combinations.
We recommend only to use the listed guide bar and saw
chain combinations.
Low kickback saw chain
A saw chain that is designated as Low kickback saw
chain, meets the low kickback requirement specified in
ANSI B175.1-2021.
Approved cutting equipment - 545 Mark II and 545G Mark II
Guide bar
Length, in/cm Pitch, in
13/33
15/38
16/41 0.325
18/46
20/50
13/33
15/38
16/41 0.325
18/46
20/50
13/33
15/38
16/41 0.325
18/46
20/50
13/33
15/38
16/41 0.325
18/46
20/50
544 - 011 - 09.11.2023
Max. nose ra-
Gauge, in/mm
dius
0.050/1.3 11T
11T
0.058/1.5
11T or 12T
11T
0.058/1.5 12T
34 mm
11T
0.050/1.3 66
72
80
Kickback and guide bar nose radius
For sprocket nose bars the nose radius is specified by
the number of teeth, such as 10T. For solid guide bars
the nose radius is specified by the dimension of the
nose radius. For a given guide bar length, you can use a
guide bar with smaller nose radius than given.
Note:
The usable cutting length is usually 1 in less
than the nominal guide bar length.
Saw chain
Type
Husqvarna
SP33G
Husqvarna
H25
Husqvarna
S35G
Husqvarna
C33
Length, drive
Low kickback
links (no.)
56
64
66 Yes
72
80
56
64
66 Yes
72
80
56
64
66 Yes
72
80
56
64
12T No
34 mm
35