Krups BeerTender Manual Del Usuario página 6

Please note that too much dust can affect the efficiency of
the cooling system of your BeerTender. It is possible that
dust enters in the machine through the vent grid at the rear
of the machine. We recommend that, using a vaccuum
cleaner, you clean regularly this particular area. This will
allow your BeerTender to last longer and remain efficient
over time.
You should never attempt to access internal parts of the
appliance.
Machine Components
BeerTender
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.
12.
14 BeerTender Keg
13.
15
14.
15.
13
4 Cautionary Notes
Using the BeerTender system
To obtain draft beer of optimal quality you should keep
two basic factors in mind, the temperature of the beer
and hygienic conditions.
1. Pre-chill the beer keg to prevent excess foam.
Always use a chilled keg. If you fail to chill the keg
sufficiently too much foam will be produced when
you start to pour your beer.
2. Always clean the appliance after use. Beer is
a natural product that can spoil. Therefore,
you should always keep the appliance clean to
maintain the quality of the beer dispensed and
avoid unpleasant odours (see "Cleaning"). The
dispensing spout should be cleaned before a new
keg is installed and the drip tray and grate should
be emptied after every use.
BeerTender dispensing system
Refrigerating chamber
Lid
Lid opening handle
LED control panel
Tap cover
Dispensing spout
Beer tap handle
Drip grate
Drip tray
Main switch
Power cord with plug
BeerTender Keg
Beer tube
BeerTender Keg tap
8
You should also follow these other rules when using the
BeerTender system:
1. Do not attempt to chill a BeerTender Keg in your
freezer. Just like glass bottles, a keg may burst
when placed in the freezer. Moreover, freezing
diminishes the quality of the beer;
2. Your BeerTender uses a technology that delivers
12°C
ultimate cooling results when the ambient
30°C
temperature is between 12°C and 30°C. At colder
temperature, the appliance cooling system could
be damaged. At warmer temperature, the cooling
system will not be able to reach the set regulation
temperature of 3°C.
Warning! To avoid overheating, always keep the
BeerTender keg out of direct sunlight. To obtain good
cooling performance, never install your machine in a
room with an ambient temperature above 30°C.
3. Always hold the appliance by the bottom edge
when lifting it.
Warning! Do not use the handle or power cord to lift the
BeerTender.
Using the Keg
Make sure that you chill the keg before using it. If you
fail to chill the keg sufficiently too much foam will be
produced when you start to pour beer.
Please also be aware that the first glass that you pour
from every new keg will contain mostly foam. Draught
beer in a bar behaves in exactly the same way!
The BeerTender Keg "Compatible BeerTender" features
a patented system for storing and dispensing beer. It
guarantees beer of higher, long-lasting quality and a
BeerTender system that is very easy and pleasant to use.
Important: Before installing a keg inside the appliance,
check the "best before end" date shown at the bottom
of the keg. This date is a reliable indication if the keg has
been stored at room temperature.
The use of kegs "Compatible BeerTender" in the
BeerTender system necessitate the use of beer tubes. A
bag of tubes is delivered with the BeerTender appliance.
To receive, free of charge, additional beer tubes please
contact our customer service via.
(see details per country at the end of this manual)
9